OpenVZ Forum


Home » General » Support » Problem Inserting Microcode (Wrong arch?)
Re: Problem Inserting Microcode (Wrong arch?) [message #24314 is a reply to message #24313] Mon, 03 December 2007 22:52 Go to previous messageGo to previous message
btgeekboy is currently offline  btgeekboy
Messages: 3
Registered: December 2007
Junior Member
I just confirmed I was able to use insmod to fix the problem. Then running `modprobe microcode` works without an issue.

It appears the init.d script simply runs `/sbin/modprobe microcode`, so I guess we could hack the init script to fix the problem, but that's treating the symptom rather than addressing the root cause.

Perhaps this is worthy of a bug report?
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: help
Next Topic: unable to install cubepanel in VE
Goto Forum:
  


Current Time: Wed Feb 28 08:28:13 GMT 2024

Total time taken to generate the page: 0.02562 seconds