OpenVZ Forum


Home » General » Support » Problem Inserting Microcode (Wrong arch?)
Re: Problem Inserting Microcode (Wrong arch?) [message #24313 is a reply to message #24301] Mon, 03 December 2007 22:33 Go to previous messageGo to previous message
tomp is currently offline  tomp
Messages: 64
Registered: August 2007
Member
Hi

I am in the identical situation to you. I too have a Dell 1950 server with nothing installed except the ovz kernel and Dell openmanage software all installed via yum.

If i insmod the microcode module from the x64 lib folder then there are no errors when i run modprobe microcode. However running the command by itself generates the same errors as appear on boot.
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: help
Next Topic: unable to install cubepanel in VE
Goto Forum:
  


Current Time: Wed Feb 28 08:15:00 GMT 2024

Total time taken to generate the page: 0.02399 seconds