OpenVZ Forum


Home » General » Support » *SOLVED* Make Kernel Module ztdummy available in VE
Re: Make Kernel Module ztdummy available in VE [message #21296 is a reply to message #16155] Thu, 04 October 2007 15:01 Go to previous messageGo to previous message
Alexandr Andreev is currently offline  Alexandr Andreev
Messages: 35
Registered: October 2006
Member
1. Had you solve the problem?

Quote:

However asterisk is compiling without its conferencing tool MeetMe, which means ztdummy is missing on the system.


2. Probably you compiled zaptel in VE0, installed kernel modules, gave access to /dev/zap to VE's, and then entered VE, and tried to compile asteriks.

If so, you should also build and install zaptel inside VE, because asterisk requires zaptel headers and libraries to enable MeetMe support.

3. To check whether ztdummy loaded successful, run in your VE
# ztcfg -v
# ztcfg -d
# cat /proc/zaptel/1


Here is all asterisk features, depending on ZAPTEL:

# grep ZAPTEL menuselect.makedeps
MENUSELECT_DEPENDS_app_flash=ZAPTEL
MENUSELECT_DEPENDS_app_meetme=ZAPTEL
MENUSELECT_DEPENDS_app_page=ZAPTEL APP_MEETME
MENUSELECT_DEPENDS_app_rpt=ZAPTEL TONEZONE
MENUSELECT_DEPENDS_app_zapbarge=ZAPTEL
MENUSELECT_DEPENDS_app_zapras=ZAPTEL
MENUSELECT_DEPENDS_app_zapscan=ZAPTEL
MENUSELECT_DEPENDS_chan_iax2=ZAPTEL
MENUSELECT_DEPENDS_chan_zap=RES_SMDI ZAPTEL_VLDTMF ZAPTEL TONEZONE PRI
MENUSELECT_DEPENDS_codec_zap=ZAPTEL_TRANSCODE ZAPTEL
MENUSELECT_DEPENDS_res_musiconhold=ZAPTEL

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: VLAN Setup
Next Topic: VLAN woes
Goto Forum:
  


Current Time: Sun Apr 21 20:22:55 GMT 2024

Total time taken to generate the page: 0.01271 seconds