OpenVZ Forum


Home » General » Support » When I Install OpenVZ, the server is not accessible. (RTL8111/8168B )
Re: When I Install OpenVZ, the server is not accessible. [message #50477 is a reply to message #50476] Sun, 01 September 2013 09:16 Go to previous messageGo to previous message
comeback is currently offline  comeback
Messages: 2
Registered: August 2013
Junior Member
Hello,

Thank you for your help.

I installed this way:

www.virtualizor.com/wiki/Install

It did not work.

I wrote to support virtualizor, they made several test and they wrote me


Quote:
Sir, can you contact DC support that when you create openvz kernel entry in grub.conf server does not boot.


I contacted the DC, they told me there was a problem with the network card.

The version of CentOS, they propose, is a modified DC Kernel for the network card works.

ifconfig -a 


dummy0    Link encap:Ethernet  HWaddr 9E:CC:4C:54:54:68
          BROADCAST NOARP  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)

eth0      Link encap:Ethernet  HWaddr 8C:89:A5:C6:B7:D4
          inet addr:xx.xxx.xxx.xx  Bcast:91.236.239.255  Mask:255.255.255.0
          inet6 addr: fe80::8e89:a5ff:fec6:b7d4/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:137053 errors:0 dropped:0 overruns:0 frame:0
          TX packets:20966 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:181762298 (173.3 MiB)  TX bytes:1788255 (1.7 MiB)
          Interrupt:41 Base address:0xc000

ip6tnl0   Link encap:UNSPEC  HWaddr 00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00
          NOARP  MTU:1452  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)

lo        Link encap:Local Loopback
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:72 errors:0 dropped:0 overruns:0 frame:0
          TX packets:72 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:8012 (7.8 KiB)  TX bytes:8012 (7.8 KiB)

sit0      Link encap:IPv6-in-IPv4
          NOARP  MTU:1480  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)

tunl0     Link encap:IPIP Tunnel  HWaddr
          NOARP  MTU:1480  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)


I replaced my ip by xx.

I restaller CentOS, there is nothing on the server.

[Updated on: Sun, 01 September 2013 09:17]

Report message to a moderator

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Script to delete VM IP on DDoS attack?
Next Topic: Can i "service network restart" on dedi?
Goto Forum:
  


Current Time: Fri Nov 01 22:09:02 GMT 2024

Total time taken to generate the page: 0.03130 seconds