OpenVZ Forum


Home » Mailing lists » Users » Feedback on Using VLAN's for production Voice VE's
Feedback on Using VLAN's for production Voice VE's [message #42237] Wed, 23 March 2011 16:12
JR Richardson is currently offline  JR Richardson
Messages: 7
Registered: May 2008
Junior Member
From: *parallels.com
Hi All,

I've been using OpenVZ with kernel 2.6.18-14-fza-686-bigmem
successfully for some time now. Running on Dell PE 2800's and have
many Asterisk VE's in production using straight NIC bridging with each
VE getting a single IP.

I have a new requirement for a VE to run 2 interfaces, one bridged
public IP and a private IP connected through a VLAN. So my idea is to
bridge the HN eth0 for my public IP's and setup eth1 as a VLAN trunk
port and bridge the VLAN's to their specific VE's.

Conceptually I understand how to do this and think I can get through
the configuration ok. I have read some posts about enabling VLAN's in
OpenVZ causes a performance hit and can produce unreliable conditions
for production use. Is there a certain kernel that works better than
another for using VLAN's? Can someone point me in the right direction
of a good howto? I'm really concerned about adding functionality that
will screw up a rock solid production system.

Any suggestions or feedback on this would be greatly appreciated.

Thanks.

JR
--
JR Richardson
Engineering for the Masses
Previous Topic: arcconf: deprecated find_task_by_pid function is used
Next Topic: Newbie question - trying to install openvz
Goto Forum:
  


Current Time: Thu May 24 19:25:04 GMT 2018