|
Re: How to use tc to limit traffic? [message #51223 is a reply to message #51222] |
Wed, 12 March 2014 00:20  |
Ales
Messages: 330 Registered: May 2009
|
Senior Member |
|
|
Well, commands like this are usualy put into a script, so you can esily repeat them or make them run automatically after each reboot.
DEV variables should be set according to your environment - it's quite possible that eth0 and venet0 are the correct values. Also, you must set the IPs (note the X.X.X.X in the code). That's how you limit a certain container - by specifying its IP.
[Updated on: Wed, 12 March 2014 00:20] Report message to a moderator
|
|
|