| DAHDI/Zaptel for Asterisk in OpenVZ (/proc issue) [message #37308] |
Wed, 02 September 2009 12:48  |
smw420
Messages: 2
Registered: September 2009
|
Junior Member |
|
|
Debian Lenny 2.6.26-2-openvz-amd64 with DAHDI 2.2.0. VE is debian-5.0-amd64-minimal with Asterisk 1.4.26.1.
Installing DAHDI or Zaptel on HN works perfectly. Inside the VE, however, things aren't working out. I have made available all the required /dev/dahdi or /dev/zap enties with proper perms and the one thing that is missing in order for Asterisk to see the timing device is /proc/dahdi or /proc/zap within the VE. On the HN...
vps1:/vz# cat /proc/dahdi/1
Span 1: WCFXO/0 "Generic Clone Board 1" (MASTER) RED
1 WCFXO/0/0 RED
(yes I have hardware, but I also tried all this with ztdummy/dahdi_dummy with the same problems)
However, in the VE, there is no /proc/dahdi/1 file at all. When Asterisk starts it acts as if everything is fine but none of the DAHDI commands are available and the Meetme application does not function properly (Asterisk DID install with Meetme app).
Since I have all my devices set up properly in the VE, I think all I need to make this work is the missing /proc entry. How on earth can I get this to happen? Is there a way to "fake" the file into /proc? I am asking the super-smart folks here in the OpenVZ forum because the /proc structure inside a VE seems to be your realm. Thanks!!!
-Mike Walker
P.S. - There seems to be a rumor that it might be working on i386 arch but I can't verify it at the moment. http://forum.openvz.org/index.php?&t=msg&goto=35554# msg_35554
[Updated on: Wed, 02 September 2009 12:51] Report message to a moderator |
|
|
|
OpenVZ Forum
Members
Search
Help
Register
Login
Home
