OpenVZ Forum: Support » Disabling all limits

Home » General » Support » Disabling all limits

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Disabling all limits [message #35622]

Wed, 08 April 2009 23:11

divB
Messages: 79
Registered: April 2009

Member

Hello,

I'm migrating from Linux VServer to OpenVZ. With VServer I did not setup any limits, so the hardware was shared among all virtual servers in a "first come, first serve" manner.

Now I sometimes get the error:

-bash: fork: Cannot allocate memory

I think it's because of the resource limit.

Is there a way to switch off all limits for all containers so that they behave the same as with VServer?

I would only do this temporarily in order to get the servers quickly up'n'running and would restore and adapt the limits afterwards...

I just do not want to have errors in my migration process which are just caused by limits (I have enough troubles with the migration Wink

)

Thank you,
divB

Report message to a moderator

[Message index]

		Disabling all limits By: divB on Wed, 08 April 2009 23:11
		Re: Disabling all limits By: maratrus on Thu, 09 April 2009 06:43
		Re: Disabling all limits By: divB on Thu, 09 April 2009 22:21
		Re: Disabling all limits By: maratrus on Fri, 10 April 2009 06:50
		Re: Disabling all limits By: divB on Fri, 10 April 2009 09:57
		Re: Disabling all limits By: maratrus on Fri, 10 April 2009 10:31
		Re: Disabling all limits By: divB on Fri, 10 April 2009 15:33

Previous Topic:	kernel/rhel5/028stab060.8 Kernel Compilation Error
Next Topic:	using /dev/ttyS0 inside a VM ?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Jun 17 09:23:12 GMT 2026

Total time taken to generate the page: 0.42918 seconds