OpenVZ Forum


Home » General » Support » veth does not ping itself. Where is the problem?
veth does not ping itself. Where is the problem? [message #35596] Tue, 07 April 2009 22:04 Go to previous message
divB is currently offline  divB
Messages: 79
Registered: April 2009
Member
Hello!

I can't ping myself in the VE. What could be the problem?

# zctl set 300 --netif_add eth0 --save
Saved parameters for VE 300
# vzctl start 300
Starting VE ...
VE is mounted
Setting CPU units: 1000
Configure meminfo: 65536
Configure veth devices: veth300.0 
VE start in progress...
# vctl enter 300
## ifconfig eth0 192.168.3.1 netmask 255.255.255.0 up
## ifconfig 
eth0      Link encap:Ethernet  HWaddr 00:18:51:8A:04:58  
          inet addr:192.168.3.1  Bcast:192.168.3.255  Mask:255.255.255.0
          inet6 addr: fe80::218:51ff:fe8a:458/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:3 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0 
          RX bytes:0 (0.0 b)  TX bytes:196 (196.0 b)
## ping 192.168.3.1
PING 192.168.3.1 (192.168.3.1) 56(84) bytes of data.
^C
--- 192.168.3.1 ping statistics ---
10 packets transmitted, 0 received, 100% packet loss, time 6012ms

##


I have not connected veth300.0 on the host to a bridge until now, but I have tried it; id did not change. In my opinion, the ping must work even when I do nothing with veth300.0 on the host...

Thank you,
divB

 
Read Message
Read Message
Read Message
Previous Topic: how to start?
Next Topic: How to rebuild a openvz kernel in linux kernel with version 2.6.24.7 ?
Goto Forum:
  


Current Time: Sun Jul 14 13:15:40 GMT 2024

Total time taken to generate the page: 0.02291 seconds