Hey there,
I just did another physical-to-VE procedure. Done it before with no problems, but this one gives me a headache.
Some relevant lines:
[root@hw28101 private]# cat /etc/vz/conf/28999.conf
# Configuration file generated by vzsplit for 1 VEs
# on HN with total amount of physical mem 4011 Mb
# low memory 4011 Mb, swap size 8095 Mb, Max treads 8000
# Resourse commit level 0:
# Free resource distribution. Any parameters may be increased
# Primary parameters
NUMPROC="20538:20538"
AVNUMPROC="10269:10269"
NUMTCPSOCK="20538:20538"
NUMOTHERSOCK="20538:20538"
VMGUARPAGES="616143:9223372036854775807"
# Secondary parameters
KMEMSIZE="841240576:925364633"
TCPSNDBUF="196289877:280413525"
TCPRCVBUF="196289877:280413525"
OTHERSOCKBUF="98144938:182268586"
DGRAMRCVBUF="98144938:98144938"
OOMGUARPAGES="616143:9223372036854775807"
PRIVVMPAGES="616143:677757"
# Auxiliary parameters
LOCKEDPAGES="41076:41076"
SHMPAGES="61614:61614"
PHYSPAGES="0:9223372036854775807"
NUMFILE="328608:328608"
NUMFLOCK="1000:1100"
NUMPTY="512:512"
NUMSIGINFO="1024:1024"
DCACHESIZE="183765250:189278208"
NUMIPTENT="200:200"
DISKSPACE="14975830:16473414"
DISKINODES="16651330:18316464"
CPUUNITS="120050"
OSTEMPLATE=debian-4.0
IP_ADDRESS="85.113.250.230"
vzlist:
[root@hw28101 private]# vzlist | grep 28999
28999 89 running 85.113.250.230 -
routing table in VE:
cleanmail:/# route -n
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.0.2.1 0.0.0.0 255.255.255.255 UH 0 0 0 venet0
0.0.0.0 192.0.2.1 0.0.0.0 UG 0 0 0 venet0
/etc/network/interfaces:
cleanmail:/# cat /etc/network/interfaces
# This configuration file is auto-generated.
# WARNING: Do not edit this file, otherwise your changes will be lost.
# Please edit template /etc/network/interfaces.template instead.
# Auto generated interfaces
auto lo
iface lo inet loopback
auto venet0
iface venet0 inet static
address 127.0.0.1
netmask 255.255.255.255
broadcast 0.0.0.0
up route add -net 192.0.2.1 netmask 255.255.255.255 dev venet0
up route add default gw 192.0.2.1
auto venet0:0
iface venet0:0 inet static
address 85.113.250.230
netmask 255.255.255.255
broadcast 0.0.0.0
iptables:
cleanmail:/# iptables -L
Chain INPUT (policy ACCEPT)
target prot opt source destination
Chain FORWARD (policy ACCEPT)
target prot opt source destination
Chain OUTPUT (policy ACCEPT)
target prot opt source destination
ifconfig:
target prot opt source destination
cleanmail:/# ifconfig
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:124 errors:0 dropped:0 overruns:0 frame:0
TX packets:124 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:10020 (9.7 KiB) TX bytes:10020 (9.7 KiB)
venet0 Link encap:UNSPEC HWaddr 00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00
inet addr:127.0.0.1 P-t-P:127.0.0.1 Bcast:0.0.0.0 Mask:255.255.255.255
UP BROADCAST POINTOPOINT RUNNING NOARP MTU:1500 Metric:1
RX packets:307 errors:0 dropped:0 overruns:0 frame:0
TX packets:296 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:24830 (24.2 KiB) TX bytes:21967 (21.4 KiB)
venet0:0 Link encap:UNSPEC HWaddr 00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00
inet addr:85.113.250.230 P-t-P:85.113.250.230 Bcast:0.0.0.0 Mask:255.255.255.255
UP BROADCAST POINTOPOINT RUNNING NOARP MTU:1500 Metric:1
/etc/resolv.conf:
cleanmail:/# cat /etc/resolv.conf
search jkit.nl
nameserver 208.67.222.222
iptables on host <snipped>:
Chain INPUT (policy ACCEPT)
target prot opt source destination
Chain FORWARD (policy ACCEPT)
target prot opt source destination
<snip>
all -- 85.113.250.230 anywhere
all -- anywhere 85.113.250.230
Chain OUTPUT (policy ACCEPT)
target prot opt source destination
Now.. maybe I'm not seeing it, but this looks all fine to me. Yet.. no traffic possible, not in, not out. Any hints?
OpenVZ Forum
Members
Search
Help
Register
Login
Home
