OpenVZ Forum


Home » General » Support » LVS and openvz
LVS and openvz [message #34245] Tue, 16 December 2008 15:13 Go to previous message
ebasley is currently offline  ebasley
Messages: 14
Registered: February 2008
Junior Member
got a huge problem with openvz and LVS.


take 2 nodes with Linux version 2.6.26-1-openvz-686 (Debian 2.6.26-11), one (vz1) has ldirectord on CT0 and one VE (ve1), next (vz2) has just one VE (ve2).
if ldirectord (from vz1) is directing traffic to vz2 : all work fine, but if traffic is redirected to local CTO (vz1) kernel thread ksoftirqd takes 100% of the cpu and nothing else happens !
With tcpdump we can see numerous paquets forwarded to ve1, something similar to a loop !!

setup :
-----

VZ1 :
----

1: lo: <LOOPBACK,UP,LOWER_UP> mtu 16436 qdisc noqueue state UNKNOWN
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
inet6 ::1/128 scope host
valid_lft forever preferred_lft forever
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP qlen 1000
link/ether 00:1f:29:0e:f9:4b brd ff:ff:ff:ff:ff:ff
inet6 fe80::21f:29ff:fe0e:f94b/64 scope link
valid_lft forever preferred_lft forever
3: br0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state UNKNOWN
link/ether 00:1f:29:0e:f9:4b brd ff:ff:ff:ff:ff:ff
inet 192.168.2.22/24 brd 192.168.2.255 scope global br0
inet 192.168.2.206/32 scope global br0
inet6 fe80::21f:29ff:fe0e:f94b/64 scope link
valid_lft forever preferred_lft forever
11: veth213.0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state UNKNOWN
link/ether 00:18:51:46:62:00 brd ff:ff:ff:ff:ff:ff
inet6 fe80::218:51ff:fe46:6200/64 scope link
valid_lft forever preferred_lft forever




/etc/network/interfaces :
auto br0
iface br0 inet static
address 192.168.2.22
netmask 255.255.255.0
network 192.168.2.0
broadcast 192.168.2.255
gateway 192.168.2.250
bridge_ports eth0

veth, eth0 are bridged in br0.
LVZ VIP (192.168.2.206) is supported by br0


ve1:
----

1: lo: <LOOPBACK,UP,LOWER_UP> mtu 16436 qdisc noqueue state UNKNOWN
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
inet 192.168.2.206/32 scope global lo
inet6 ::1/128 scope host
valid_lft forever preferred_lft forever

3: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state UNKNOWN
link/ether 00:18:51:59:12:98 brd ff:ff:ff:ff:ff:ff
inet 192.168.2.213/24 brd 192.168.2.255 scope global eth0
inet6 fe80::218:51ff:fe59:1298/64 scope link
valid_lft forever preferred_lft forever

/etc/network/interfaces :
auto lo
iface lo inet loopback
post-up /bin/ip addr add 192.168.2.206 dev lo


auto eth0
iface eth0 inet static
address 192.168.2.213
netmask 255.255.255.0
gateway 192.168.2.250
dns-nameservers 194.2.0.20 195.68.0.1
dns-search hdf-finance.fr
post-up /sbin/sysctl -w net.ipv4.conf.eth0.arp_ignore="1"
post-up /sbin/sysctl -w net.ipv4.conf.eth0.arp_annouce="2"

Help will be wellcome.
Thanks
Eric

 
Read Message
Read Message
Read Message
Previous Topic: Openvz proxy arp or snat?
Next Topic: kernel problem !!
Goto Forum:
  


Current Time: Sun Jun 30 23:17:56 GMT 2024

Total time taken to generate the page: 0.02810 seconds