OpenVZ Forum: Support » Is it possible to postpone/schedule the vzquota recalculation (after HN power failures etc)?

Home » General » Support » Is it possible to postpone/schedule the vzquota recalculation (after HN power failures etc)?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Is it possible to postpone/schedule the vzquota recalculation (after HN power failures etc)? [message #31389]

Thu, 26 June 2008 12:35

motin
Messages: 1
Registered: June 2008

Junior Member

Upon HN power failures etc, it will take our VE:s around 4-5 hours to start because of vzquota recalculation. Having the VE:s start and then recalculate one on one (using VZFASTBOOT=yes) sounds like a step in the right direction, but still means a lot of sudden down-time for each VE.

Is there any possibility to schedule this recalculation to run at a certain time, so that it can be performed during low-traffic hours or planned maintenance time?

Note: This was written as a reply to this thread: http://forum.openvz.org/index.php?t=msg&goto=30200& , which is read only.

Report message to a moderator

[Message index]

		Is it possible to postpone/schedule the vzquota recalculation (after HN power failures etc)? By: motin on Thu, 26 June 2008 12:35
		Re: Is it possible to postpone/schedule the vzquota recalculation (after HN power failures etc)? By: maratrus on Wed, 02 July 2008 11:23

Previous Topic:	MYSQL in container
Next Topic:	Network configuration

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Sep 02 20:30:44 GMT 2026

Total time taken to generate the page: 0.18665 seconds