OpenVZ Forum: Support » 2.6.18-53.1.6.el5.028stab053.6PAE + ipv6 = not happy

Home » General » Support » 2.6.18-53.1.6.el5.028stab053.6PAE + ipv6 = not happy

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

2.6.18-53.1.6.el5.028stab053.6PAE + ipv6 = not happy [message #28050]

Thu, 06 March 2008 20:25

broquea
Messages: 20
Registered: December 2007

Junior Member

So I was running on 2.6.18-53.1.4.el5.028stab053.4PAE up until 2.6.18-53.1.6.el5.028stab053.6PAE had been made available. After switching over, I found that the HN and the VEs all still had IPv6 configured and running on them, however even with the default route in place, they couldn't get out. I could ping the gateway, but anything beyond was "no route to host". I rebooted back into 53.4PAE and everything worked again.

I meant to bring this up earlier after the kernel had been released but have been busy. I'm still running on 53.4PAE because IPv6 connectivity is a requirement for my system.

Report message to a moderator

[Message index]

		2.6.18-53.1.6.el5.028stab053.6PAE + ipv6 = not happy By: broquea on Thu, 06 March 2008 20:25
		Re: 2.6.18-53.1.6.el5.028stab053.6PAE + ipv6 = not happy By: koct9i on Fri, 07 March 2008 13:45
		Re: 2.6.18-53.1.6.el5.028stab053.6PAE + ipv6 = not happy By: broquea on Fri, 07 March 2008 22:17

Previous Topic:	New Kernel 2.6.24 out
Next Topic:	VPS for Oracle, requires SWAP partition

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Apr 28 05:55:56 GMT 2024

Total time taken to generate the page: 0.02721 seconds