OpenVZ Forum


Home » Mailing lists » Devel » Re: [PATCH 1/1] Dynamically allocate the loopback device
Re: [PATCH 1/1] Dynamically allocate the loopback device [message #19758] Fri, 24 August 2007 17:43 Go to previous message
Stephen Hemminger is currently offline  Stephen Hemminger
Messages: 37
Registered: August 2006
Member
On Fri, 24 Aug 2007 19:55:47 +0400
"Denis V. Lunev" <dlunev@gmail.com> wrote:

> dlezcano@fr.ibm.com wrote:
> > From: Daniel Lezcano <dlezcano@fr.ibm.com>
> > 
> > Doing this makes loopback.c a better example of how to do a
> > simple network device, and it removes the special case
> > single static allocation of a struct net_device, hopefully
> > making maintenance easier.
> > 
> > Applies against net-2.6.24
> > 
> > Tested on i386, x86_64
> > Compiled on ia64, sparc
> 
> I think that a small note, that initialization order is changed will be
> good to record. After this, loopback MUST be allocated before any other
> networking subsystem initialization. And this is an important change.
> 
> Regards,
>     Den

Yes, this code would break when other drivers are directly linked
in. 
_______________________________________________
Containers mailing list
Containers@lists.linux-foundation.org
https://lists.linux-foundation.org/mailman/listinfo/containers
 
Read Message
Read Message
Read Message
Previous Topic: [PATCH] Use helpers to obtain task pid in printks (arch code)
Next Topic: Fwd: [LTP] Containers Testcases Plan
Goto Forum:
  


Current Time: Sat Aug 02 07:09:56 GMT 2025

Total time taken to generate the page: 0.70913 seconds