Hello All,
I have installed a machine at a client.
I want access to the following ip's 10.11.15.101
10.1.4.191
10.1.4.192
10.1.1.191
10.1.1.192
10.200.6.1
with the gateway ip 10.0.254.2. This has been achieved in the base instance with the following net.eth0config_eth0=( "10.0.253.72 netmask 255.255.0.0 broadcast 10.0.255.255" )
routes_eth0=( "10.0.253.0/24 via 10.0.254.2"
"default via 10.0.254.2" )
However the VE (there is only one ATM) works perfectly except it cannot see either of the 10.1.4 addresses.
I don't have a clue what is going on and I would be very grateful if you can point out the error of my ways
Following is what is seen in the base instance and the VE. If you want any more information, please ask.BASE-INSTANCE conf.d # netstat -rn
Kernel IP routing table
Destination Gateway Genmask Flags MSS Window irtt Iface
10.0.253.0 10.0.254.2 255.255.255.0 UG 0 0 0 eth0
10.0.0.0 0.0.0.0 255.255.0.0 U 0 0 0 eth0
127.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0 lo
0.0.0.0 10.0.254.2 0.0.0.0 UG 0 0 0 eth0
BASE-INSTANCE conf.d # vzctl enter 201
entered into VE 201
VE-LIVE / # netstat -rn
Kernel IP routing table
Destination Gateway Genmask Flags MSS Window irtt Iface
192.0.2.0 0.0.0.0 255.255.255.0 U 0 0 0 venet0
127.0.0.0 127.0.0.1 255.0.0.0 UG 0 0 0 lo
0.0.0.0 192.0.2.1 0.0.0.0 UG 0 0 0 venet0
VE-LIVE / # cat /etc/conf.d/net
config_venet0=( "10.0.253.133/32" )
routes_venet0=( "-net 192.0.2.0/24" "default via 192.0.2.1" )
Thanks in advance, Best Regards, Paul.
[Updated on: Mon, 21 May 2007 10:24]
Report message to a moderator