OpenVZ Forum: Support » Problem with notebook

Members

Help

Home

Home » General » Support » Problem with notebook

Show: Today's Messages :: Show Polls :: Message Navigator

E-mail to friend

Problem with notebook [message #36930]

Fri, 31 July 2009 14:05

cub-uanic
Messages: 7
Registered: July 2009

Junior Member

From: *cub.org.ua

Hello,

I have Dell Studio 1535 notebook, running Debian/Lenny and OpenVZ. All software was installed in usual way, from Debian repositories.

While I connected to network, all working well. There is no difference is this network wired or wireless. And so, I have some real interface (eth0 or wlan0) in UP state. But when I drop network connection (leave wireless zone, or unplug cable) - all VE's become unaccessible. At first look, all that is needed for correct throughput, is here. I mean, interface is up (venet0), and route to each VE is still here. And from other side, from VE, all is same - interface is up, and route is present. But network is not working - VE not responding even to simple ping. If I try to bring up some real interface manually, all start working again. For example, I can assign some fake ip to eth0, and bring it up, and all works just fine (I even don't need to connect wire to network card - interface state UP is enough, and state of link does not matter).

Is this known problem, and how I can get all working without magic actions with fake ip?

Thanks in advance.

Report message to a moderator

Re: Problem with notebook [message #36942 is a reply to message #36930]

Mon, 03 August 2009 04:06

maratrus
Messages: 1495
Registered: August 2007
Location: Moscow

Senior Member

From: *sw.ru

Hi,

Quote:

But when I drop network connection (leave wireless zone, or unplug cable) - all VE's become unaccessible.

From where do VEs become unaccessible?

Report message to a moderator

Re: Problem with notebook [message #36943 is a reply to message #36942]

Mon, 03 August 2009 05:24

cub-uanic
Messages: 7
Registered: July 2009

Junior Member

From: *cub.org.ua

From hardware host

Report message to a moderator

Re: Problem with notebook [message #36944 is a reply to message #36943]

Mon, 03 August 2009 05:29

maratrus
Messages: 1495
Registered: August 2007
Location: Moscow

Senior Member

From: *sw.ru

Why do you expect HN to communicate to VEs?
HN has no interfaces with any ip address assigned to so what interface should VE communicate to?
BTW, communication between VEs should work.

Report message to a moderator

Re: Problem with notebook [message #36945 is a reply to message #36930]

Mon, 03 August 2009 05:34

cub-uanic
Messages: 7
Registered: July 2009

Junior Member

From: *cub.org.ua

Why not?
HW have loopback interface and venet interface.
Is this not enough to succesfull communication?

Report message to a moderator

Re: Problem with notebook [message #36946 is a reply to message #36945]

Mon, 03 August 2009 05:49

maratrus
Messages: 1495
Registered: August 2007
Location: Moscow

Senior Member

From: *sw.ru

Quote:

HW have loopback interface

loopback interface is not intended for communication between two different hosts.

Quote:

and venet interface.

venet0 interface doesn't have any ip addresses assigned on the HN.
If you want you may assign an arbitrary ip address to venet0 (nothing should be broken but communication should work).

Report message to a moderator