Disable Networking on VE, but only allow traffic from venet0:0 [message #39253] |
Fri, 02 April 2010 16:01 |
EXT3FSCK
Messages: 1 Registered: April 2010
|
Junior Member |
|
|
I am working on a cluster-able solution using openVZ.
There is one thing that I am stuck on, is I need IP addresses added to the VE , but I need for them not to be route able at all, just venet0:0 , I just need them there so scripts on the node can read the IPs. Its using a closed code control panel so no other way to modify it.
My best solution is to somehow make the VE only route traffic from venet0:0, but ignore anything else. venet0:* other than venet0:0 I want it ignored, not routeable, etc, but at least it can show when doing "ip addr show" in a CentOS template.
Is it possible somehow in openVZ to get this done ?
If so how would someone go to do this?
|
|
|
|