OpenVZ Forum


Home » General » Support » COMPAQ/HP ARRAY SUPPORT
COMPAQ/HP ARRAY SUPPORT [message #305] Wed, 09 November 2005 09:09 Go to next message
henrydenhengst is currently offline  henrydenhengst
Messages: 1
Registered: November 2005
Junior Member
The compaq/hp array (scsi disk) is not supported in the openvz kernels, in short cparray, like it is in any edition of RH, Fedora or CentOS.

Can anyone tell me how it should be compiled into the kernel, than I will make the kernels of course available for anyone.

THANX

Report message to a moderator

Re: COMPAQ/HP ARRAY SUPPORT [message #306 is a reply to message #305] Wed, 09 November 2005 09:35 Go to previous messageGo to next message
dim is currently offline  dim
Messages: 344
Registered: August 2005
Senior Member
It is supported. Support is compiled in kernel instead of in module support in "any edition of RH, Fedora or CentOS".

http://static.openvz.org/openvz_userbar_en.gif

Report message to a moderator

Re: COMPAQ/HP ARRAY SUPPORT [message #307 is a reply to message #306] Wed, 09 November 2005 11:24 Go to previous message
kir is currently offline  kir
Messages: 1645
Registered: August 2005
Location: Moscow, Russia
Senior Member
Henry, that means you
(1) don't need initrd specifically for cparray if using openvz kernel
(2) can safely ignore warnings from mkinitrd that tells module xxx is not found -- this is because indeed there is no separate module, driver is compiled into kernel

Kir Kolyshkin
http://static.openvz.org/userbars/openvz-developer.png

Report message to a moderator

Previous Topic: iptables - host node or VPSes?
Next Topic: java problem
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Mon Oct 19 19:49:13 GMT 2026

Total time taken to generate the page: 1.09727 seconds
Powered by FUDforum Powered by Virtuozzo Containers