OpenVZ Forum


Home » General » Support » Port shaping / Rate limit do not work in openvz containers
Port shaping / Rate limit do not work in openvz containers [message #39566] Wed, 12 May 2010 05:31
whatever is currently offline  whatever
Messages: 142
Registered: September 2006
Senior Member
We are facing strange problem with the containers. We have set the port speed of the vps to 20mbps but the vps are able to burst 100mbps.
Openvz rate limit/port shaping work for inbound or just outbound traffic from the container?
Is it possible to limit the speed to X mbps and vps cannot use more then that.

Thanks

Report message to a moderator

Previous Topic: ufw support in OpenVZ ubuntu container.
Next Topic: something strange with /proc
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Sat May 17 03:28:51 GMT 2025

Total time taken to generate the page: 0.04162 seconds
Powered by FUDforum Powered by Virtuozzo Containers