OpenVZ Forum


Home » General » Support » How to set mtu in a container
How to set mtu in a container [message #37608] Wed, 30 September 2009 09:11 Go to next message
bujam1 is currently offline  bujam1
Messages: 2
Registered: September 2009
Junior Member
Hi to all,

This is my first post, in this forum, so please be lenient.

I have to change the mtu setting in a container and i was wondering if this parameter can be set in xxx.conf file, so that the setting can be remembered upon restart...
(I'm using v3.0.23 of vzctl)

I've read the docs/searched the web, but i couldn't find any indication on how to do it... Any ideas?

Thanks in advance,
Theodoros


ps. I suppose i could write a script, that would be executed upon starting the container, but if there is a parameter in the .conf file, i would prefer using it, because it is more 'clear' Smile
Re: How to set mtu in a container [message #37683 is a reply to message #37608] Fri, 09 October 2009 15:15 Go to previous messageGo to next message
maratrus is currently offline  maratrus
Messages: 1495
Registered: August 2007
Location: Moscow
Senior Member
Hello,

I'm afraid that the script is the best way to change MTU because there is no such parameter.
Re: How to set mtu in a container [message #37700 is a reply to message #37683] Mon, 12 October 2009 07:58 Go to previous message
bujam1 is currently offline  bujam1
Messages: 2
Registered: September 2009
Junior Member
I'll probably go for the script, then. Thanks for the reply!
Previous Topic: migrationg VE's from kernel 2.6.8 to 2.6.24-ovz009.1
Next Topic: Asterisk Meetme and Dahdi (Zaptel) issue on 64bit HN
Goto Forum:
  


Current Time: Sun Apr 14 02:26:08 GMT 2024

Total time taken to generate the page: 0.01975 seconds