OpenVZ Forum


Home » General » Support » No physical login to hardware node
No physical login to hardware node [message #37468] Mon, 14 September 2009 23:34 Go to next message
mlowrie is currently offline  mlowrie
Messages: 5
Registered: May 2008
Junior Member
Hi,

I typically access the HN via ssh, but today I attempted to access it via the console, but on two HN's I have, no login prompt is present.

The booting sequence ends with the containers starting, but nothing after that.

Did I miss something or is my system messed up?

I'm running Fedora 9 HN with the 2.6.18-92.1.1.el5.028stab057.2 kernel.

Thanks,
Mike
Re: No physical login to hardware node [message #37471 is a reply to message #37468] Tue, 15 September 2009 08:10 Go to previous messageGo to next message
kir is currently offline  kir
Messages: 1645
Registered: August 2005
Location: Moscow, Russia
Senior Member

Check that there are mingetty processes running (ps ax | grep getty); they should be.

If they are not, check configs. Those mingetties are run either from /etc/inittab or from /etc/event.d/tty*, depending on whether F9 is using SysVinit or upstart.


Kir Kolyshkin
http://static.openvz.org/userbars/openvz-developer.png
Re: No physical login to hardware node [message #37489 is a reply to message #37468] Wed, 16 September 2009 18:04 Go to previous message
mlowrie is currently offline  mlowrie
Messages: 5
Registered: May 2008
Junior Member
No mingetty is running, and everything is correct in /etc/event.d/tty*.

Bootup messages give:
dmz-hn1 kernel: console [tty0] enabled

But then I see
dmz-hn1 init: tty2 main process (1435) killed by TERM signal

This is obviously something with Fedora. I'll find a Fedora forum and post the question there.

Thanks for the help,
Mike
Previous Topic: Searching Linux Headers
Next Topic: VEs in more than one subnet/with more than one NIC
Goto Forum:
  


Current Time: Tue Feb 27 15:03:20 GMT 2024

Total time taken to generate the page: 0.03026 seconds