|
|
|
|
| Re: IPv6 support in VE [message #12850 is a reply to message #12811] |
Fri, 11 May 2007 14:46   |
|
|
Jan,
With venet, you use the same ipadd command, for example:
vzctl set VEID --ipadd fc00::01 --save
Before that, make sure that
* your kernel is compiled with IPv6
* ipv6 module is loaded (if IPv6 is compiled as a module)
* IPV6 set to yes in /etc/vz/vz.conf
Kirill Korotaev wrote:
> Jan,
>
> venet supports IPv6 addresses as well.
> it's just an article concerning veth only :)
>
> Thanks,
> Kirill
>
> Jan Tomasek wrote:
>
>> Hello,
>>
>> what is state of IPv6 support inside VE? I found:
>>
>> http://wiki.openvz.org/Virtual_Ethernet_device#Virtual_ether net_device_with_IPv6
>>
>> but that looks quite complicated comparing to IPv4 where I just need to
>> use `vzctl --ipadd 1.2.3.4` and that is all.
>>
>> Do I have to go with veth or is there chance how to configure IPv6 on venet?
>>
>> Thanks for sugestions
>>
>>
>> ------------------------------------------------------------ ------------
>>
|
|
|
|
| Re: IPv6 support in VE [message #13032 is a reply to message #12850] |
Thu, 17 May 2007 21:37 |
Thorsten Schifferdeck
Messages: 38
Registered: February 2006
|
Member |
|
|
Hi,
adding is ok, but when i want delete a IPv6 with --ipdel, it shows:
# vzctl set <VEID> --ipdel fc00::1 [--save]
Warning: ipv6 support disabled <---*
Deleting IP address(es):
Configure meminfo: 49152
Saved parameters for VE <VEID>
Regards,
Thorsten
> Jan,
>
> With venet, you use the same ipadd command, for example:
>
> vzctl set VEID --ipadd fc00::01 --save
>
> Before that, make sure that
> * your kernel is compiled with IPv6
> * ipv6 module is loaded (if IPv6 is compiled as a module)
> * IPV6 set to yes in /etc/vz/vz.conf
>
> Kirill Korotaev wrote:
>> Jan,
>>
>> venet supports IPv6 addresses as well.
>> it's just an article concerning veth only :)
>>
>> Thanks,
>> Kirill
>>
>> Jan Tomasek wrote:
>>
>>> Hello,
>>>
>>> what is state of IPv6 support inside VE? I found:
>>>
>>> http://wiki.openvz.org/Virtual_Ethernet_device#Virtual_ether net_device_with_IPv6
>>>
>>>
>>> but that looks quite complicated comparing to IPv4 where I just need to
>>> use `vzctl --ipadd 1.2.3.4` and that is all.
>>>
>>> Do I have to go with veth or is there chance how to configure IPv6 on
>>> venet?
>>>
>>> Thanks for sugestions
>>>
>>>
>>> ------------------------------------------------------------ ------------
>>>
|
|
|
|
OpenVZ Forum
Members
Search
Help
Register
Login
Home
