OpenVZ Forum: Support » No answer to ARP

Home » General » Support » No answer to ARP

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

No answer to ARP [message #39353]

Thu, 08 April 2010 16:36

justasp
Messages: 7
Registered: May 2009

Junior Member

Hi All,

I have strange problem with ARP. Situation is like this:

There is HN with 2 network interfaces. One is connected to internal network, other to public. On HN there are several VE, some using veth and some venet. For one VE that is using venet and public routable IP, HN does not answer to arp who-has. For other VEs - everything is fine.

When I try to connect to IP of VE (let's say X) I see on public facing interface:
ovz-vps4:/home/justas# tcpdump -i eth0 arp and host X
tcpdump: verbose output suppressed, use -v or -vv for full protocol decode
listening on eth0, link-type EN10MB (Ethernet), capture size 96 bytes
19:14:34.517097 arp who-has X tell Y
19:14:35.516909 arp who-has X tell Y
19:14:36.516729 arp who-has X tell Y

And there are no response, that X is at something.

In VE conf there are only these lines about network:
HOSTNAME="db0.AAAAAA.tld"
IP_ADDRESS="X"

During startup we run this script on a HN:
iptables -A FORWARD -s 0/0 -d X -j GOOD;
iptables -A FORWARD -s X -d 0/0 -j GOOD;

Anyone have any clues what might be wrong?

Thanks a LOT!

Report message to a moderator

Re: No answer to ARP [message #39354 is a reply to message #39353]

Thu, 08 April 2010 17:01

justasp
Messages: 7
Registered: May 2009

Junior Member

Mods - please delete this thread.
Solved it myself, had accidentally removed:
ip rule add from X table 10
for source based routing during reconfig....

Report message to a moderator

Previous Topic:	How to sync "production" host into "test" host?
Next Topic:	Segmentation Fault with Novell eDirectory

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue Sep 22 21:29:04 GMT 2026

Total time taken to generate the page: 0.33934 seconds