OpenVZ Forum: Support » OpenVZ on SheevaPlug

Home » General » Support » OpenVZ on SheevaPlug

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

OpenVZ on SheevaPlug [message #37825]

Mon, 26 October 2009 19:43

tomkamphuys
Messages: 2
Registered: October 2009

Junior Member

I've read that OpenVz was successfully ported to ARM and used on a gumstix overo. I would like to use OpenVZ on a Sheevaplug ( http://www.marvell.com/products/embedded_processors/kirkwood /plugcomputer.jsp). Is this possible?

Report message to a moderator

Re: OpenVZ on SheevaPlug [message #37826 is a reply to message #37825]

Mon, 26 October 2009 21:27

kir
Messages: 1645
Registered: August 2005
Location: Moscow, Russia

Senior Member

In theory, yes (but you have to do some manual patching and building). In practice, I haven't tried it, since I don't have the hardware.

Kir Kolyshkin

http://static.openvz.org/userbars/openvz-developer.png

Report message to a moderator

Re: OpenVZ on SheevaPlug [message #37841 is a reply to message #37826]

Tue, 27 October 2009 17:02

tomkamphuys
Messages: 2
Registered: October 2009

Junior Member

Nice to hear that it is possible!

Are you (or anybody) interested in helping me? I've limited knowledge of linux and C, but it would be nice if I could get this up and running. I also think that more people will be interested in OpenVZ on an ARM architecture.

Here's some more info on the sheevaplug:
SheevaPlug computer:
http://www.marvell.com/products/embedded_processors/kirkwood /plugcomputer.jsp

with a:
88F6281 CPU by Marvell

with this architecture:
armv5tej(l)

Report message to a moderator

Previous Topic:	ip_conntrack: CT 0: table full, dropping packet.
Next Topic:	Template and Wrong permision's.

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Aug 02 03:16:38 GMT 2026

Total time taken to generate the page: 1.00621 seconds