OpenVZ Forum: Support » How do I access a serial usb device from a VE?

Home » General » Support » How do I access a serial usb device from a VE? (How do I access a serial usb device from a VE?)

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

How do I access a serial usb device from a VE? [message #37743]

Thu, 15 October 2009 18:43

JimL
Messages: 116
Registered: February 2007

Senior Member

I have an embedded processor (Arduino) I want to be able to access from a piece of software that talks with it over a USB connection. I can't seem to figure out how to expose the USB port to a VE.

It's not a disk so bind mount doesn't seem to be the solution.

Thanks,
Jim.

Report message to a moderator

Re: How do I access a serial usb device from a VE? [message #37744 is a reply to message #37743]

Thu, 15 October 2009 21:41

ramjet
Messages: 16
Registered: September 2009

Junior Member

On a 1U HP sever which only has one on-board serial port I added DEVNODES="ttyS0:rw " to the configuration. It's one year ago so I can't remember if I used vzctl:

from vzctl(8):

Device access management

--devnodes device:r|w|rw|none
Give the container an access (r - read only, w - write only,
rw - read/write, none - no access) to a device designated by
the special file /dev/device. Device file is created in a
container by vzctl.

--devices b|c:major:minor|all:[r|w|rw|none]
Give the container an access to a block or character device
designated by its major and minor numbers. Device file have
to be created manually.

You can also read OpenVZ-Users-Guide.pdf: pg 66 Advanced tasks, Accessing Devices from Inside Virtual Private Server.

You will probably need to add DEVNODES="ttyUSB0:rw" but maybe udev on HN will make it more complicated. I can test it tomorrow at work if above doesn't work for you.

Report message to a moderator

Re: How do I access a serial usb device from a VE? [message #37749 is a reply to message #37744]

Fri, 16 October 2009 12:55

JimL
Messages: 116
Registered: February 2007

Senior Member

ramjet wrote on Thu, 15 October 2009 17:41

On a 1U HP sever which only has one on-board serial port I added DEVNODES="ttyS0:rw " to the configuration. It's one year ago so I can't remember if I used vzctl:

You will probably need to add DEVNODES="ttyUSB0:rw" but maybe udev on HN will make it more complicated. I can test it tomorrow at work if above doesn't work for you.

The DEVNODES="ttyUSB0:rw" worked perfectly.

Thanks,
Jim.

Report message to a moderator

Previous Topic:	fork: Cannot allocate memory
Next Topic:	tap device support

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Sep 21 23:12:31 GMT 2026

Total time taken to generate the page: 0.69163 seconds