OpenVZ Forum


Home » General » Support » How can I bind a VE IP address to a physical ethernet interface?
How can I bind a VE IP address to a physical ethernet interface? [message #20096] Tue, 11 September 2007 22:47 Go to next message
fgomes is currently offline  fgomes
Messages: 29
Registered: August 2006
Junior Member
Sorry if this was already answered, I swear I've searched the forum before posing this question (and also the manual) Smile
If I have more than one NIC in the host, can I force each VE network traffic to use a specific NIC? Thanks!

Fernando

Report message to a moderator

Re: How can I bind a VE IP address to a physical ethernet interface? [message #20100 is a reply to message #20096] Wed, 12 September 2007 08:21 Go to previous message
maratrus is currently offline  maratrus
Messages: 1495
Registered: August 2007
Location: Moscow
Senior Member
Hi,
you can solve your problem by using bridges:

Let's assume, that you have two interfaces eth0, eth1 on your HN and two VEs(VE101, VE102)

1.Use veth instead of venet.
http://wiki.openvz.org/Veth
http://wiki.openvz.org/Differences_between_venet_and_veth

2. You can bind VE101's network traffic to eth0 and VE102's to eth1 by creating veth101.0, veth102.0 interfaces and then creating two bridges uniting eth0,veth101.0 and eth1,veth102.0.

Report message to a moderator

Previous Topic: Problems suspending VE with 2.6.18-028stab039
Next Topic: kernel: EDAC k8 MC0: GART TLB errorr: transaction type(generic), cache level(generic)
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Sep 23 00:00:26 GMT 2026

Total time taken to generate the page: 0.95906 seconds
Powered by FUDforum Powered by Virtuozzo Containers