OpenVZ Forum: Support » How to allow OpenVZ to take advantage of timing source?

Home » General » Support » How to allow OpenVZ to take advantage of timing source?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

How to allow OpenVZ to take advantage of timing source? [message #50289]

Mon, 12 August 2013 15:09

torontob
Messages: 1
Registered: August 2013

Junior Member

Hi everyone,

I am using Proxmox and have many OpenVZ containers of CentOS in it.

I have installed a Sangoma UT50 VoiceTimer timing device on mothernode and Dahdi from Digium. It is running fine and timing accuracy is 99.9%+. Now, how do I allow the OpenVZ container to use the same timing device?

Do I need to install Dahdi and OpenVZ drivers on container too?
Or is there just an allowing process or symlink process or make the drivers available to OpenVZ?

Thanks,

Report message to a moderator

Re: How to allow OpenVZ to take advantage of timing source? [message #50345 is a reply to message #50289]

Sat, 17 August 2013 08:19

dipps
Messages: 22
Registered: May 2013
Location: Out in the scrub

Junior Member

Does your timing device adjust the kernel time on the hostnode? If so, Job Done, because it's the same kernel that appears in your container.

I know nothing about the timing device: but if it appears as a device file /dev/WHATEVER, you can make that available inside the container. See the bit about devnodes in "man vzctl". Here's an example:

forum.openvz.org/index.php?t=msg&th=6393

Report message to a moderator

Previous Topic:	Passthrough device when plugged in
Next Topic:	Missing PPTP module in debian kernel

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Sep 20 21:46:11 GMT 2026

Total time taken to generate the page: 0.11888 seconds