Multiple interfaces eth0, eth1 on different subnets [message #9978] |
Thu, 01 February 2007 19:05 |
pyite
Messages: 20 Registered: January 2007
|
Junior Member |
|
|
Hello there. I am trying to put my OpenVZ machine on multiple networks so I can create a VPS on any of the VLAN's here.
I am running into two problems:
1) When I start a VPS, it always does the arpsend on eth0. This isn't fatal, just a warning
2) The fatal error: VPS on the eth1 interface are unable to route anywhere - they can only connect to the local network. I am assuming that this is because the default route on the machine is on eth0. Is there any way to set a default route inside of the VPS that is different from the default route outside?
Thanks,
Mark
|
|
|