OpenVZ Forum: Support » VPS&cPanel: High processor load

Home » General » Support » VPS&cPanel: High processor load

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: VPS&cPanel: High processor load [message #8659 is a reply to message #8616]

Thu, 30 November 2006 14:09

dev
Messages: 1693
Registered: September 2005
Location: Moscow

Senior Member

cpulimit is measured in percents of CPU.
100 means 1 CPU (100%), 200 means 2 CPUs etc.
if you have 4 CPUs, then you can tune cpulimit from 1 to 400, which
allows VE to use from 0 to 4CPUs available.

when you set cpulimit to 75 you have limited VE to 0.75*N_CPUS of your CPU power.
NOTE: cpulimit has nothing to do with cpuunits!

http://static.openvz.org/userbars/openvz-developer.png

Report message to a moderator

[Message index]

		VPS&cPanel: High processor load By: fransonline on Tue, 28 November 2006 11:15
		Re: VPS&cPanel: High processor load By: rickb on Tue, 28 November 2006 15:20
		Re: VPS&cPanel: High processor load By: fransonline on Tue, 28 November 2006 23:07
		Re: VPS&cPanel: High processor load By: rickb on Tue, 28 November 2006 23:11
		Re: VPS&cPanel: High processor load By: fransonline on Wed, 29 November 2006 08:44
		Re: VPS&cPanel: High processor load By: rickb on Wed, 29 November 2006 08:48
		Re: VPS&cPanel: High processor load By: fransonline on Wed, 29 November 2006 12:27
		Re: VPS&cPanel: High processor load By: dev on Thu, 30 November 2006 14:09
		Re: VPS&cPanel: High processor load By: fransonline on Thu, 30 November 2006 22:08
		Re: VPS&cPanel: High processor load By: rickb on Wed, 29 November 2006 13:39
		Re: VPS&cPanel: High processor load By: jonwatson on Mon, 16 April 2007 15:42

Previous Topic:	SOLVED 2 subnet in an VPS
Next Topic:	Connecting VM eth0 to guest tap device

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Jul 12 08:35:21 GMT 2026

Total time taken to generate the page: 0.33057 seconds