OpenVZ Forum


Home » General » Support » SOLVED * Veth on startup (again) + bridge config - venet config
Re: Veth on startup (again) + bridge config - venet config [message #8440 is a reply to message #8434] Mon, 20 November 2006 10:04 Go to previous messageGo to previous message
sylvain is currently offline  sylvain
Messages: 6
Registered: November 2006
Junior Member
Ok I got my answer by looking in the forum:

The variable OSTEMPLATE= associated with a proper configuration in "/etc/vz/dists" initialize venet0 from inside the VE at startup.

I will change all the script to initialize ethX from inside the VE, creating a new distribution "fake" and setting my OSTEMPLE to this distribution.

When I am done I will provide the script in this forum, hope it could help someone else.

Maybe future release could actually provide for:
distribution-net.conf and distribution-eth.conf that would configure the Ethernet interface instead of the network interface?


I am just making a very modest suggestion with very limited knowledge...

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Services crashing inside of VE
Next Topic: SOLVED* Cloned but the mysqld timed out in cloned VE
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Mon Aug 31 14:16:54 GMT 2026

Total time taken to generate the page: 0.20911 seconds
Powered by FUDforum Powered by Virtuozzo Containers