OpenVZ Forum


Home » Mailing lists » Users » OpenVZ and VMWare or Parallels on the same host?
Re: OpenVZ and VMWare or Parallels on the same host? [message #8250 is a reply to message #8242] Sat, 11 November 2006 20:49 Go to previous messageGo to previous message
Lyndsay Roger is currently offline  Lyndsay Roger
Messages: 3
Registered: May 2006
Junior Member
Yes you can run vmware with an openvz kernel. I have two machines set up
like that. They are using the older 2.6.16 series of test kernels b it
should also work for the newer 2.6.28 series as well.

It will not find a suitable module for the kernel and will just compile its
own which worked fine for me.

Have not tried Parallels.

Have fun,
Lyndsay




On 11/11/06, Jim Nightshade <jim@hepe.com> wrote:
>
> Is it possible to load VMWare kernel modules into an OpenVZ kernel and
> run VMware on the host? Is it possible to use Parallels alongside
> OpenVZ? I mean on the host, not in the guests.
>
> Would such a setup require a special network configuration? What if I
> put two Ethernet adapters into the box? Could I use one interface for
> OpenVZ and the other one for VMware or Parallels?
>

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Quotas / Disk Space
Next Topic: [Devel] linux.conf.au 2007 Virtualization mini-conf CFP
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed May 27 04:23:43 GMT 2026

Total time taken to generate the page: 0.27803 seconds
Powered by FUDforum Powered by Virtuozzo Containers