OpenVZ Forum


Home » Mailing lists » Devel » [Q] ide cdrom in native mode leads to irq storm?
Re: [Q] ide cdrom in native mode leads to irq storm? [message #7853 is a reply to message #7754] Fri, 27 October 2006 13:17 Go to previous messageGo to previous message
vaverin is currently offline  vaverin
Messages: 708
Registered: September 2005
Senior Member
Vasily Averin wrote:
> Vasily Averin wrote:
>> there is node with Intel 7520-based motherboard (MSI-9136), IDE cdrom (hda) and
>> SATA disc and 2.6.19-rc3 linux kernel.
>>
>> When I set IDE controller into the native mode, I get irq storm on the node and
>> this interrupt is disabled. If this interrupt is shared, the other subsystems
>> are stop working too.
>>
>> When I switch the IDE controller into legacy mode, all works correctly.

I have reproduced the same issue on the another node:

ASUSTeK P5GD1-VM,
Intel 915G chipset,
ICH6 IDE controller,
IDE dvdrom: SONY DVD-ROM DDU1615 (hda),
sata disk: WDC WD1600JS-00M

when I switch IDE controller to the native mode, I see "Disabling IRQ" message,
then kernel generates an oops in create_empty_buffers(), like I've reported earlier.

Could somebody please help me to troubleshoot this issue? I've seen this issue
on the customer nodes and would like to know how I can work-around this issue
without any changes inside motherboard BIOS.

thank you,
Vasily Averin
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: [PATCH] i2c-ixp4xx: fix ") != 0))" typo
Next Topic: [PATCH] retries in ext3_prepare_write() violate ordering requirements
Goto Forum:
  


Current Time: Mon Jul 21 16:43:43 GMT 2025

Total time taken to generate the page: 0.08598 seconds