OpenVZ Forum


Home » General » Support » *SOLVED* No parallel port on VE
Re: No parallel port on VE [message #7649 is a reply to message #7616] Thu, 19 October 2006 13:19 Go to previous messageGo to previous message
ferp2 is currently offline  ferp2
Messages: 29
Registered: May 2006
Junior Member
Quote:

what do you mean by that? how is it inaccessible?
what are the exact messages on the screen/logs etc.?
what are the commands you are trying to execute and fail?


After doing vzctl set <veid> --devnodes lp0:rw, there is still no /dev/lp0 device in the VE. As a result I cannot print from the VE. When I set up the printer in CUPS, I cannot set the device URI to the parallel port because there is no parallel port. Here's what happens when I try to print directly to the device:

Quote:


echo "sdfsdf" > /dev/lp0
bash: /dev/lp0: No such device or address


I have found a temporary solution to this problem as follows:
To be able to print to the /dev/lp0 device in the VE, I have to start the cups daemon in the HN. I have to do this every time I reboot the HN server.

Please note that I have already done vzctl set <veid> --devnodes lp0:rw --save.

Thank you.

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: *SOLVED* Masquerade and OVZ in IPCOP ?
Next Topic: Accessing VE from 2 different networks
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Jul 01 03:09:04 GMT 2026

Total time taken to generate the page: 0.58509 seconds
Powered by FUDforum Powered by Virtuozzo Containers