OpenVZ Forum: Support » How to properly set memory limits

Home » General » Support » How to properly set memory limits

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: How to properly set memory limits [message #743 is a reply to message #629]

Sun, 08 January 2006 18:15

rsaylor
Messages: 43
Registered: December 2005

Member

Ok, I have altered my mem config a little. With this test below I do not get any conflicts anymore.

vzctl set 134148 --kmemsize 4915200:5242880 --privvmpages 98304:107150 --vmguarpages 98304:2147483647 --numproc 130 --tcprcvbuf 638976:1048576 --dgramrcvbuf 264192 --save

WHERE 134148 is the VPSID

Report message to a moderator

[Message index]

		How to properly set memory limits By: rsaylor on Thu, 29 December 2005 15:36
		Re: How to properly set memory limits By: dev on Thu, 29 December 2005 17:51
		Re: How to properly set memory limits By: rsaylor on Thu, 29 December 2005 18:01
		Re: How to properly set memory limits By: dev on Thu, 29 December 2005 18:04
		Re: How to properly set memory limits By: rsaylor on Thu, 29 December 2005 18:21
		Re: How to properly set memory limits By: kir on Sat, 07 January 2006 13:30
		Re: How to properly set memory limits By: rsaylor on Sun, 08 January 2006 18:15

Previous Topic:	what sripts runs when you vzctl into a ve?
Next Topic:	Hybodus OpenVZ Template :)

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Aug 29 08:31:09 GMT 2026

Total time taken to generate the page: 0.57622 seconds