Re: Re: template Gentoo, Init [message #7212 is a reply to message #7210] |
Fri, 06 October 2006 17:22 |
|
1. This is not Virtuozzo support. If you are Virtuozzo customer, ask
their support. If you are hosting customer -- ask you HSP support.
2. Steps of modifying a new Gentoo installation to adopt it to OpenVZ
are described at http://wiki.openvz.org/Gentoo_template_creation
(starting from the item #5). I can not guarantee they are applicable to
Virtuozzo.
Tonko Mulder wrote:
> It was already set to 'no'..
> setting it to 'yes' didn't make any difference
>
>>> Hi,
>
>>> Tonko Mulder wrote:
>> Hello all,
>>
>> I have the gentoo template running on a virtuozzo server..
>> Only I have the following problem, every time I want to boot my
>> virtual machine it goes to init 0..
>> the init gets it's commands from inittab, but I don't know exactly if
>> that should be adapted for a virtual machine..
>>> Try adapting RC_PARALLEL_STARTUP="no" in /etc/conf.d/rc. This makes
>>> sometimes problems ;)
>>
>> regards
>>> Regards,
>>> Martin
>
> On 10/2/06, Tonko Mulder <tonko.mulder@gmail.com> wrote:
>> Hello all,
>>
>> I have the gentoo template running on a virtuozzo server..
>> Only I have the following problem, every time I want to boot my
>> virtual machine it goes to init 0..
>> the init gets it's commands from inittab, but I don't know exactly if
>> that should be adapted for a virtual machine..
>>
>> regards
>> --
>> Tonko
>>
>
>
|
|
|