OpenVZ Forum: Support » How to properly set memory limits

Home » General » Support » How to properly set memory limits

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: How to properly set memory limits [message #630 is a reply to message #629]

Thu, 29 December 2005 17:51

dev
Messages: 1693
Registered: September 2005
Location: Moscow

Senior Member

check the last column in output of `cat /proc/user_beancounters`
this column contains number of resource rejects. if it is more than zero than you have a too much strong limit for this resource, so you can increase it via `vzctl set ...`

http://static.openvz.org/userbars/openvz-developer.png

[Updated on: Sat, 07 January 2006 13:20] by Moderator

Report message to a moderator

[Message index]

		How to properly set memory limits By: rsaylor on Thu, 29 December 2005 15:36
		Re: How to properly set memory limits By: dev on Thu, 29 December 2005 17:51
		Re: How to properly set memory limits By: rsaylor on Thu, 29 December 2005 18:01
		Re: How to properly set memory limits By: dev on Thu, 29 December 2005 18:04
		Re: How to properly set memory limits By: rsaylor on Thu, 29 December 2005 18:21
		Re: How to properly set memory limits By: kir on Sat, 07 January 2006 13:30
		Re: How to properly set memory limits By: rsaylor on Sun, 08 January 2006 18:15

Previous Topic:	what sripts runs when you vzctl into a ve?
Next Topic:	Hybodus OpenVZ Template :)

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue May 26 00:31:30 GMT 2026

Total time taken to generate the page: 0.41929 seconds