OpenVZ Forum


Home » General » Support » *SOLVED* Multiple IP - Speed?
Re: Multiple IP - Speed? [message #6061 is a reply to message #5989] Thu, 07 September 2006 13:37 Go to previous messageGo to previous message
chinaman is currently offline  chinaman
Messages: 15
Registered: August 2006
Junior Member
Thanks for the instructions.
After installing new kernel with veth support veth devices are running now. So far I can see the speed is the same as HW now.

But due to veth there are some new questions now:

1. I add veth and eth0 device to bridge in HW node. I had to set a route to IP of VPS to veth device, otherwise I couldn't reach the VPS. Is this correct? I thought there is no routing necessary bcs. of the bridge.

2. How can I automatically assign IP to eth0 device in VPS? If i use /etc/network/interfaces the file is empty after restarting VPS.

3. After restarting the VPS the veth dev in HW was down. I had to do the whole procedure (adding to bridge ...) manually again. Is it possible to do this automatically?

Thanks.

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: IPV6 Support in VPS
Next Topic: Setting up VZ Partitions?
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Fri Aug 28 16:57:04 GMT 2026

Total time taken to generate the page: 0.45349 seconds
Powered by FUDforum Powered by Virtuozzo Containers