OpenVZ Forum: Users » Problem using arptables on hw-node

Home » Mailing lists » Users » Problem using arptables on hw-node

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Problem using arptables on hw-node [message #5861]

Fri, 01 September 2006 15:18

Fabian Kropp
Messages: 8
Registered: September 2006

Junior Member

Hi,

I just discovered problems when using srptables on a bridge the veth of
the VE and the eth of the hw-node are connected to.

is there anything known about arptables and OpenVZ ??

Thank you

Fabian

Report message to a moderator

[Message index]

		Problem using arptables on hw-node By: Fabian Kropp on Fri, 01 September 2006 15:18
		Re: Problem using arptables on hw-node By: dev on Mon, 04 September 2006 08:35
		Re: Problem using arptables on hw-node By: Fabian Kropp on Mon, 04 September 2006 08:46
		Re: Re: Problem using arptables on hw-node By: Cranky on Mon, 04 September 2006 08:37

Previous Topic:	binfmt-support ?
Next Topic:	How to reset UBC failcnt

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Feb 15 15:37:13 GMT 2026

Total time taken to generate the page: 0.52402 seconds