OpenVZ Forum: Support » Nat table is not able to access

Home » General » Support » Nat table is not able to access (adding NAT rules in iptables getting error )

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Nat table is not able to access [message #53399 is a reply to message #53396]

Fri, 06 July 2018 02:50

vaverin
Messages: 708
Registered: September 2005

Senior Member

Dear arunksasi,
could you please clarify -- is it happen inside container or on host?

If this observed on host -- please check state of ip_conntrack_disable_ve0 option of nf_conntrack module.
(in Vz6 we disable conntracks on host by default, but in openvz6 it should be enabled)

If this happen inside container -- please check state of NETFILTER option in conainer's config file
NETFILTER="full" should enable using of NAT rules.

https://openvz.org/Using_NAT_for_container_with_private_IPs
https://openvz.org/Setting_up_an_iptables_firewall

Report message to a moderator

[Message index]

		Nat table is not able to access By: arunksasi on Thu, 05 July 2018 08:35
		Re: Nat table is not able to access By: arunksasi on Thu, 05 July 2018 10:06
		Re: Nat table is not able to access By: vaverin on Fri, 06 July 2018 02:50

Previous Topic:	net.ipv4.ip_forward
Next Topic:	conntrack in OpenVZ 7

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Jan 17 13:18:16 GMT 2026

Total time taken to generate the page: 0.33255 seconds