OpenVZ Forum: Support » Kernel Panic after booting to openvz2.6 kernel

Home » General » Support » Kernel Panic after booting to openvz2.6 kernel (Os :Debian 9.4 . getting kerne; panic after booting to openvz kernel . )

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Kernel Panic after booting to openvz2.6 kernel [message #53343 is a reply to message #53342]

Wed, 13 June 2018 12:23

vaverin
Messages: 708
Registered: September 2005

Senior Member

"Bad pagetable: 000d"
0xd -- so called error code, it describes the reason of the page fault.

/*
* Page fault error code bits:
*
* bit 0 == 0: no page found 1: protection fault
* bit 1 == 0: read access 1: write access
* bit 2 == 0: kernel-mode access 1: user-mode access
* bit 3 == 1: use of reserved bit detected
* bit 4 == 1: fault was an instruction fetch
*/

In this case kernel was not expected that bit3 us set.

I never saw such kind of issues before.

Error code is generated by CPU, so reason of this incident should be explained in CPU documentation.
Could you please clarify exact version of CPU used on affected node?

In general I can advise to update firmware (i.e motherboard BIOS) on affected node.

Thank you,
Vasily Averin

Report message to a moderator

[Message index]

		Kernel Panic after booting to openvz2.6 kernel By: arunksasi on Wed, 13 June 2018 09:55
		Re: Kernel Panic after booting to openvz2.6 kernel By: vaverin on Wed, 13 June 2018 12:23
		Re: Kernel Panic after booting to openvz2.6 kernel By: vaverin on Wed, 13 June 2018 12:51
		Re: Kernel Panic after booting to openvz2.6 kernel By: vaverin on Wed, 13 June 2018 15:03

Previous Topic:	Error installing Openvz 7
Next Topic:	centOS vulnerabilities detected by Nessus

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Dec 05 05:03:49 GMT 2025

Total time taken to generate the page: 0.32364 seconds