OpenVZ Forum: Support » port forwarding if using bridge

Home » General » Support » port forwarding if using bridge

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: port forwarding if using bridge [message #51587 is a reply to message #51564]

Wed, 06 August 2014 17:03

devonblzx
Messages: 127
Registered: December 2006

Senior Member

ebtables runs alongside iptables and is for bridges. I'd suspect that the syntax is very similar but you may need to use the MAC address of the veth device instead of the IP address like you would with venet/iptables.

There are examples on their site you can review: http://ebtables.sourceforge.net/examples/basic.html

You're going to have to do some fooling around with it if noone else here can help but be sure to share your input here or consider writing a page on the wiki if you find some things out.

http://static.openvz.org/userbars/openvz-user-2.png

ByteOnSite President

[Updated on: Wed, 06 August 2014 17:04]

Report message to a moderator

[Message index]

		port forwarding if using bridge By: hkendusers on Mon, 28 July 2014 12:01
		Re: port forwarding if using bridge By: hkendusers on Mon, 04 August 2014 02:38
		Re: port forwarding if using bridge By: devonblzx on Wed, 06 August 2014 00:14
		Re: port forwarding if using bridge By: hkendusers on Wed, 06 August 2014 07:01
		Re: port forwarding if using bridge By: devonblzx on Wed, 06 August 2014 17:03

Previous Topic:	Ploop Error
Next Topic:	Mount a XFS partition inside VE with raw io ?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Dec 05 22:54:32 GMT 2025

Total time taken to generate the page: 0.10095 seconds