OpenVZ Forum: Support » Asterisk G.729 codec...

Home » General » Support » Asterisk G.729 codec...

Wed, 24 October 2012 17:40

ugob
Messages: 271
Registered: March 2007

Senior Member

What is the exact command line that you used? Don't forget that you must substitute $VEID for the ID of the container you want to configure.

Please read the manual before asking questions:
http://download.openvz.org/doc/OpenVZ-Users-Guide.pdf

Please have a look at the wiki before asking questions:
http://wiki.openvz.org/Main_Page

		Asterisk G.729 codec... By: ugob on Tue, 12 June 2007 13:27
		Re: Asterisk G.729 codec... By: curx on Tue, 12 June 2007 15:49
		Re: Asterisk G.729 codec... By: ugob on Tue, 12 June 2007 16:35
		Re: Asterisk G.729 codec... By: curx on Wed, 13 June 2007 09:33
		Re: Asterisk G.729 codec... By: ugob on Wed, 13 June 2007 11:21
		Re: Asterisk G.729 codec... By: Vasily Tarasov on Thu, 14 June 2007 10:04
		Re: Asterisk G.729 codec... By: ugob on Thu, 14 June 2007 19:51
		Re: Asterisk G.729 codec... By: Vasily Tarasov on Fri, 15 June 2007 06:21
		Re: Asterisk G.729 codec... By: ugob on Wed, 12 September 2007 12:09
		Re: Asterisk G.729 codec... By: ugob on Fri, 05 October 2007 16:39
		Re: Asterisk G.729 codec... By: ugob on Tue, 16 October 2007 12:59
		Re: Asterisk G.729 codec... By: ugob on Tue, 16 October 2007 13:08
		Re: Asterisk G.729 codec... By: bobot23 on Tue, 23 October 2012 23:30
		Re: Asterisk G.729 codec... By: ugob on Wed, 24 October 2012 17:40

Previous Topic:	vzctl exec command
Next Topic:	100% CPU usage

Goto Forum:

] [

]

Current Time: Wed Jan 14 18:33:17 GMT 2026

Total time taken to generate the page: 0.32019 seconds