OpenVZ Forum


Home » Mailing lists » Users » occasional high loadavg without any noticeable cpu/memory/io load
Re: occasional high loadavg without any noticeable cpu/memory/io load [message #46452 is a reply to message #46441] Tue, 22 May 2012 10:49 Go to previous messageGo to previous message
Rene Dokbua is currently offline  Rene Dokbua
Messages: 24
Registered: May 2012
Junior Member
Hi Esme,

> Did you check the /proc/user_beancounters of that VPS? Sometime’s a high
load could be caused by buffers that are full.

Thanks for the suggestion, much appreciated!

I didn't think of checking at the time I'm afraid. I suppose since the
container has not been rebooted since, the beancounters should still show
any problems encountered at the time right?

Below is the user_beancounters of the problem CT. I notice physpages and
dcachesize have maxheld values very close to limits (even if failcnt is
zero) could that have been the cause?


uid resource held maxheld
barrier limit failcnt
1407: kmemsize 252703307 1124626432
1932525568 2147483648 0
lockedpages 0 15
524288 524288 0
privvmpages 893372 5683554
9223372036854775807 9223372036854775807 0
shmpages 23 7399
9223372036854775807 9223372036854775807 0
dummy 0 0
0 0 0
numproc 136 480
9223372036854775807 9223372036854775807 0
physpages 733468 1048591
0 1048576 0
vmguarpages 0 0
0 9223372036854775807 0
oomguarpages 137691 676209
0 9223372036854775807 0
numtcpsock 101 459
9223372036854775807 9223372036854775807 0
numflock 7 37
9223372036854775807 9223372036854775807 0
numpty 1 4
9223372036854775807 9223372036854775807 0
numsiginfo 0 66
9223372036854775807 9223372036854775807 0
tcpsndbuf 4024896 34884168
9223372036854775807 9223372036854775807 0
tcprcvbuf 1654784 7520256
9223372036854775807 9223372036854775807 0
othersockbuf 195136 3887232
9223372036854775807 9223372036854775807 0
dgramrcvbuf 0 155848
9223372036854775807 9223372036854775807 0
numothersock 130 346
9223372036854775807 9223372036854775807 0
dcachesize 222868425 1073741824
965738496 1073741824 0
numfile 3853 12765
9223372036854775807 9223372036854775807 0
dummy 0 0
0 0 0
dummy 0 0
0 0 0
dummy 0 0
0 0 0
numiptent 197 197
9223372036854775807 9223372036854775807 0

I'm not that familiar with the nitty-gritties of the beancounters but these
are the values I have in the 1407.conf file.

PHYSPAGES="0:4096M"
SWAPPAGES="0:8192M"
KMEMSIZE="1843M:2048M"
DCACHESIZE="921M:1024M"
LOCKEDPAGES="2048M"
PRIVVMPAGES="unlimited"
SHMPAGES="unlimited"
NUMPROC="unlimited"
VMGUARPAGES="0:unlimited"
OOMGUARPAGES="0:unlimited"
NUMTCPSOCK="unlimited"
NUMFLOCK="unlimited"
NUMPTY="unlimited"
NUMSIGINFO="unlimited"
TCPSNDBUF="unlimited"
TCPRCVBUF="unlimited"
OTHERSOCKBUF="unlimited"
DGRAMRCVBUF="unlimited"
NUMOTHERSOCK="unlimited"
NUMFILE="unlimited"
NUMIPTENT="unlimited"

When user_beancounters physpage limit is 1048576, with PHYSPAGES set to
4GB, then the held value of 733468 should correspond to about 3GB, right?
But top only shows about 1.5GB used at the same time - how is that
possible?

dcachesize I think is filesystem stuff? But there seems to be plenty of
resources there;

# df -i
Filesystem Inodes IUsed IFree IUse% Mounted on
/dev/simfs 20000000 3046139 16953861 16% /
none 524288 109 524179 1% /dev
# df -h
Filesystem Size Used Avail Use% Mounted on
/dev/simfs 492G 156G 312G 34% /
none 2.0G 4.0K 2.0G 1% /dev

Best,
Rene

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: cat: /proc/self/mountinfo: Cannot allocate memory
Next Topic: vmstat and floating point exception
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Tue Oct 13 08:14:14 GMT 2026

Total time taken to generate the page: 0.49931 seconds
Powered by FUDforum Powered by Virtuozzo Containers