OpenVZ Forum


Home » Mailing lists » Users » fuse filesystem inside a container?
fuse filesystem inside a container? [message #43368 is a reply to message #43367] Wed, 31 August 2011 17:38 Go to previous messageGo to previous message
George Georgalis is currently offline  George Georgalis
Messages: 4
Registered: August 2011
Junior Member
Hi, (resending with the correct devices command)

I'm relativity new to openvz but I think I got a good idea about
managing containers, not looked much at the kernel side though. I'm
trying to port an application running on a set of hosts, to containers
running on the same hardware. The application requires both fuse and
md devices/filesystems.

I'm able to make the md/fuse devices but I've been unable to configure
a container to additionally include fuse filesystem capability.

vzctl set $id --devices b:9:2:rw --devices c:10:229:rw --save

then after starting the containers,

vzctl exec $id mknod /dev/fuse c 10 229
vzctl exec $id mknod /dev/md2 b 9 2

I'm using the standard CentOS 5.6 template and running with the following rpms:
# rpm -aq | grep vz
vzquota-3.0.12-1
ovzkernel-devel-2.6.18-238.19.1.el5.028stab092.2
ovzkernel-2.6.18-238.19.1.el5.028stab092.2
vzctl-lib-3.0.28.3-1
vzctl-3.0.28.3-1

Fuse is being used to mount a gluster filesystem. Am I missing a step?

-George

--
George Georgalis, (415) 894-2710, http://www.galis.org/

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Dual networks. Routing issue?
Next Topic: Problem comtainer
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Sat Sep 05 20:43:22 GMT 2026

Total time taken to generate the page: 0.04834 seconds
Powered by FUDforum Powered by Virtuozzo Containers