OpenVZ Forum: Support » kmemsize, shmpages: failcnt>0 while maxheld<barrier

Home » General » Support » kmemsize, shmpages: failcnt>0 while maxheld<barrier

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: kmemsize, shmpages: failcnt>0 while maxheld<barrier [message #40752 is a reply to message #40731]

Tue, 28 September 2010 07:59

hpvi
Messages: 3
Registered: May 2010

Junior Member

Perhaps did you try to launch 2 times a job which employs more than 21000 shmpages? Such a job can crash with "bus error" (or other) without modifying "maxheld"...

[Updated on: Tue, 28 September 2010 09:58]

Report message to a moderator

[Message index]

		kmemsize, shmpages: failcnt>0 while maxheld<barrier By: Wireless on Sat, 25 September 2010 04:30
		Re: kmemsize, shmpages: failcnt>0 while maxheld<barrier By: hpvi on Tue, 28 September 2010 07:59
		Re: kmemsize, shmpages: failcnt>0 while maxheld<barrier By: Wireless on Tue, 28 September 2010 14:58

Previous Topic:	Setup multiple assigned IP blocks for IPtable firewall
Next Topic:	Bridge Connection

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Jul 31 17:12:21 GMT 2026

Total time taken to generate the page: 0.15815 seconds