OpenVZ Forum: Support » running cobbler inside a CT

Home » General » Support » running cobbler inside a CT (cobbler setup problem)

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: running cobbler inside a CT [message #40198 is a reply to message #40179]

Fri, 30 July 2010 09:20

maratrus
Messages: 1495
Registered: August 2007
Location: Moscow

Senior Member

Hello,

I terribly sorry for delay.
I don't have any specific configuration.
Moreover, I tried to create a VE from scratch.
So I guess your configuration is OK.
I know nothing about cobbler but it seems that
I'd done an action which I didn't mention in
previous post because I simply didn't notice
that. The action is the following

# service cobblerd status
cobblerd is stopped
# service cobblerd start
Starting cobbler daemon:                      [  OK  ]

Hope it will help.

Report message to a moderator

[Message index]

		running cobbler inside a CT By: olojoh1977 on Fri, 23 July 2010 13:58
		Re: running cobbler inside a CT By: maratrus on Fri, 23 July 2010 14:39
		Re: running cobbler inside a CT By: olojoh1977 on Sat, 24 July 2010 08:45
		Re: running cobbler inside a CT By: olojoh1977 on Tue, 27 July 2010 06:55
		Re: running cobbler inside a CT By: maratrus on Fri, 30 July 2010 09:20
		Re: running cobbler inside a CT By: olojoh1977 on Fri, 30 July 2010 12:21
		Re: running cobbler inside a CT By: maratrus on Fri, 30 July 2010 19:36
		Re: running cobbler inside a CT By: olojoh1977 on Fri, 30 July 2010 19:43
		Re: running cobbler inside a CT By: maratrus on Sat, 31 July 2010 19:28
		Re: running cobbler inside a CT By: pasencorelui on Fri, 24 September 2010 19:37

Previous Topic:	[Help] - Ip change
Next Topic:	IPs constantly disconnecting

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu May 28 01:12:41 GMT 2026

Total time taken to generate the page: 0.50056 seconds