OpenVZ Forum


Home » General » Support » Folllowed Quick Install Guide... No External Networking
Re: Folllowed Quick Install Guide... No External Networking [message #40144 is a reply to message #40143] Thu, 22 July 2010 15:45 Go to previous messageGo to previous message
blaise is currently offline  blaise
Messages: 7
Registered: May 2010
Junior Member
I looked into /et/resolv.conf inside the container and found that nameserver has the same IP of the host. I changed it to the IP of the DSL. This works fine. I can now ping IP and domains from the container. However, if I restart the host, the nameserver is reset to the host's IP again. Actually it is reset to an IP that the host USED to have when networking was configured with DHCP on eth0.

Actually one of my old OpenVZ installations (centos host - centos VE) (which I did not install myself) has nameserver (at the container level) set to the IP of the host and everything works fine.

Another problem that I am having is the hostname which is reading: [root@unknown-<mac-address-of-eth0> ~]

Still also the iptables errors that I mentioned in my previous post.

Blaise

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Performance in my server is slow with 18 VEs. Normal ?
Next Topic: No longer setting hostname in container ?
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Sun Aug 30 03:04:29 GMT 2026

Total time taken to generate the page: 0.48074 seconds
Powered by FUDforum Powered by Virtuozzo Containers