OpenVZ Forum: Support » OpenVZ with bridged interfaces and VLAN

Home » General » Support » OpenVZ with bridged interfaces and VLAN (OpenVZ with bridged interfaces and VLAN)

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: OpenVZ with bridged interfaces and VLAN [message #39864 is a reply to message #39818]

Fri, 11 June 2010 12:35

maratrus
Messages: 1495
Registered: August 2007
Location: Moscow

Senior Member

Hello,

I might miss a point but veth103.0 cannot be added to br0.110 because the last one is VLAN interface.
I think that you shouldn't create br0.110 but just leave a single br0 which contains physical interface of the HN (possibly eth0) and veth103.0. Then add vlan interfaces using vconfig utility inside the VE and this should work.

Report message to a moderator

[Message index]

		OpenVZ with bridged interfaces and VLAN By: deimosfr on Sun, 06 June 2010 07:44
		Re: OpenVZ with bridged interfaces and VLAN By: maratrus on Fri, 11 June 2010 12:35
		Re: OpenVZ with bridged interfaces and VLAN By: deimosfr on Sat, 12 June 2010 16:30
		Re: OpenVZ with bridged interfaces and VLAN By: Nilesh Bairagi on Mon, 16 April 2012 16:44
		Re: OpenVZ with bridged interfaces and VLAN By: pateutz on Sat, 07 July 2012 20:56
		Re: OpenVZ with bridged interfaces and VLAN By: deimosfr on Mon, 09 July 2012 23:44
		Re: OpenVZ with bridged interfaces and VLAN By: pateutz on Mon, 09 July 2012 23:50
		Re: OpenVZ with bridged interfaces and VLAN By: deimosfr on Tue, 10 July 2012 11:34
		Re: OpenVZ with bridged interfaces and VLAN By: pateutz on Tue, 10 July 2012 23:44
		Re: OpenVZ with bridged interfaces and VLAN By: bdube on Sun, 13 January 2013 14:57

Previous Topic:	need to connect my centos container to the wifi
Next Topic:	Xorg - no render extension inside VE

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue May 26 18:05:20 GMT 2026

Total time taken to generate the page: 0.16684 seconds