OpenVZ Forum


Home » General » Support » LSB init script for each VPS (Need init script for each VPS)
Re: LSB init script for each VPS [message #38285 is a reply to message #38280] Thu, 03 December 2009 19:19 Go to previous messageGo to previous message
unxs is currently offline  unxs
Messages: 21
Registered: September 2009
Location: Oregon, USA
Junior Member
HA autnomoic failover is a very hard problem. You should use an external service status program (a script that actually can tell if a given service is working via protocol answers etc.) to determine if your container is not working. Avoid split-brain problems with smart fencing. (Google all these buzzwords. Wikipedia also has tons of info.)

My experience is that what usually fails is the complete hardware node. (i.e. all the containers.) So first make sure you can failover everything to a standby hardware node. And that these containers are always kept fresh -but in a working fashion. No good to sync broken config or other files to your standbys and expect them to work. As you can see nothing here is easy. Concentrate on only a single specific service, this reduces the complexity.

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: bug in vzctl 3.0.23-1pve3
Next Topic: dlm in openvz kernel
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Nov 26 13:34:44 GMT 2025

Total time taken to generate the page: 0.30077 seconds
Powered by FUDforum Powered by Virtuozzo Containers