OpenVZ Forum: Support » Ethernet bonding with bridge device on CentOS 5.3

Home » General » Support » Ethernet bonding with bridge device on CentOS 5.3

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Ethernet bonding with bridge device on CentOS 5.3 [message #37779]

Tue, 20 October 2009 16:50

batfastad
Messages: 15
Registered: September 2009
Location: London, UK

Junior Member

Hi everyone

I'm planning to consolidate a pair of servers onto an existing "beast" box we have and since this beast has 2 GbE sockets and our switch supports dynamic 802.3ad link aggregation with LACP, I'm looking to have those 2 GbE sockets combined into a mode 4 bonded interface.

My first step will be to install the openvz kernel and get that running.
Then before I create any VEs I will get the bond created and working as per this guide... http://wiki.openvz.org/Bonding
Making a slight change to specify mode=4 in modprobe.conf

But how do I then go about combining a veth/bridge with my bond0 interface?

This was the veth tutorial I was planning to follow to setup veths for each VE
http://wiki.openvz.org/Virtual_Ethernet_device#Simple_config uration_with_virtual_Ethernet_device

Then adding each veth into the bridge device
http://wiki.openvz.org/Virtual_Ethernet_device#Virtual_Ether net_devices_can_be_joined_in_one_bridge

Because these are all "virtual" networking devices, I'm guessing (hoping!) it's something simple like just adding a route for all traffic to go from bond0 to br0 and vice-versa
However I have no idea how to do that

Is any of this correct?
Anyone got any pointers on how to combine my bonded link with a bridge device?
Is it even possible?

Cheers, B

Report message to a moderator

[Message index]

		Ethernet bonding with bridge device on CentOS 5.3 By: batfastad on Tue, 20 October 2009 16:50
		Re: Ethernet bonding with bridge device on CentOS 5.3 By: ramjet on Tue, 20 October 2009 20:03
		Re: Ethernet bonding with bridge device on CentOS 5.3 By: batfastad on Tue, 20 October 2009 21:29
		Re: Ethernet bonding with bridge device on CentOS 5.3 By: maratrus on Sat, 24 October 2009 11:25
		Re: Ethernet bonding with bridge device on CentOS 5.3 By: batfastad on Wed, 28 October 2009 17:03
		Re: Ethernet bonding with bridge device on CentOS 5.3 By: maratrus on Fri, 30 October 2009 10:45

Previous Topic:	iptables v1.3.5: can't initialize iptables table `mangle': Table does not exist (do you need to insm
Next Topic:	Has ext4 (prod) been backported to 2.6.27?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Jul 10 23:26:51 GMT 2026

Total time taken to generate the page: 0.39428 seconds